I'm going to migrate two SUP32 cards to two RSP720 cards. Curently, we have two C7604 (iBGP session between them, one active and the other one for backup with one SUP32 inside. To make some tests on the futures RSP720 cards (iOS "installation", pre-configuring, link tests...), I envisage to plug the new card in the backup C7604.
In Cisco Documentation, I find that you must insert RSP720card in slot 1 or 2:
Both supervisor engines in a single chassis must be identical.
Slot 1 is reserved for the supervisor engine, which provides switching, local and remote management, and multiple GBIC uplink ports.
Slot 2 can contain a redundant supervisor engine that can act as a backup if the first supervisor engine fails. If a redundant supervisor engine is not required, slot 2 is available for an OSM or other supported Catalyst 6500 series modules.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.