I have configured PPPOE configuration in 1700 router. Some times I am getting slow performance issue while accessing the internet application, I have configured half duplex in E0 interface which is connected in internet modem. But I am not sure modem in full or half duplex. When I am configured half duplex I am getting Collection in E0 interface. So I have set full duplex mode that time I am getting CRC and frame errors but performance is better then half duplex. Please any one help me .
Re: Collection , CRC and frame error in 1700 router
Hi, my company has many T1 and telco circuits and you can generate CRC error due to a large amount of collisions, as the first post suggested check your cables and make sure there is no noise or other interferance, also if you are getting interface resets you should contact the telco and have them test the line for you. Have a look at the link below they have detailed information on troubleshooting link errors. HTH
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...