cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
593
Views
0
Helpful
1
Replies

Command -enable to execute commands in new Stby SUP.

mahesh_kv3
Level 1
Level 1

I had installed a new SUP module in the router.Now that is in Standbymode and in RPR mode(STANDBY COLD).I could not execute any commands in standby sup module.which is the command to start the utility to work this???

Many Thanks in Advance.

1 Reply 1

Laurent Aubert
Cisco Employee
Cisco Employee

Hi,

It's expected as the standby SUP is not completely booted in RPR mode.

You need to be in RPR+ or SSO mode and so having the same IOS release on both SUP

HTH

Laurent.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: