07-05-2006 12:37 AM - edited 03-03-2019 01:14 PM
Hello,
I want to know if the command ? Channel-group 0 unframed? is available in the router 3640 with a 12.3 version.
if not what is the solution?
Thanks
07-05-2006 01:17 AM
i beliave it is available
# controller S 0/0 press enter, put ? , it will give you different combincation,
i hope this will solve your problem
-Minu
07-05-2006 01:39 AM
it not exist!!!
******************************
router(config-controller)#?
Controller configuration commands:
channel-group Specify the timeslots to channel-group mapping for an
interface
clock Specify the clock source for a DS1 link
default Set a command to its defaults
description Controller specific description
exit Exit from controller configuration mode
framing Specify the type of Framing on a E1 link
guard-timer Guard timer (0-20) for xcsp calls - timer duration and
accept/reject on expiry
help Description of the interactive help system
linecode Specify the line encoding method for a E1 link
loopback Put the entire E1 line into loopback
no Negate a command or set its defaults
pri-group Configure the specified timeslots for PRI
shutdown Shut down a E1 link (send Blue Alarm)
*************************************************
router(config-controller)#channel-group ?
<0-30> Channel number
router(config-controller)#channel-group 0 ?
timeslots List of timeslots in the channel group
************************************************
07-05-2006 01:46 AM
Hi
what is effect of this command"Channel-group 0 unframed"
10xs
07-06-2006 09:48 PM
Hi
Are you trying this with E1 or T1 link ?
This option is supported only with E1 link.
regds
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: