Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

command for controller

Hello,

I want to know if the command ? Channel-group 0 unframed? is available in the router 3640 with a 12.3 version.

if not what is the solution?

Thanks

4 REPLIES
Bronze

Re: command for controller

i beliave it is available

# controller S 0/0 press enter, put ? , it will give you different combincation,

i hope this will solve your problem

-Minu

New Member

Re: command for controller

it not exist!!!

******************************

router(config-controller)#?

Controller configuration commands:

channel-group Specify the timeslots to channel-group mapping for an

interface

clock Specify the clock source for a DS1 link

default Set a command to its defaults

description Controller specific description

exit Exit from controller configuration mode

framing Specify the type of Framing on a E1 link

guard-timer Guard timer (0-20) for xcsp calls - timer duration and

accept/reject on expiry

help Description of the interactive help system

linecode Specify the line encoding method for a E1 link

loopback Put the entire E1 line into loopback

no Negate a command or set its defaults

pri-group Configure the specified timeslots for PRI

shutdown Shut down a E1 link (send Blue Alarm)

*************************************************

router(config-controller)#channel-group ?

<0-30> Channel number

router(config-controller)#channel-group 0 ?

timeslots List of timeslots in the channel group

************************************************

New Member

Re: command for controller

Hi

what is effect of this command"Channel-group 0 unframed"

10xs

Re: command for controller

Hi

Are you trying this with E1 or T1 link ?

This option is supported only with E1 link.

regds

106
Views
0
Helpful
4
Replies
CreatePlease to create content