Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Command to reload an ATM route processor module

The redundant route processor (RP) module on an 8540 ATM switch must have crashed. It is probably in rommon mode. I'm pretty sure the command does not exist, but is there a way I can reset the RP module alone? The equivalent would be on a Cat6500 'reload <module>' command. I'm not up to driving many miles to reseat the module or console into it.

1 REPLY
Silver

Re: Command to reload an ATM route processor module

When the configuration register is set for manual booting, issuing the reload command causes the system to enter ROM monitor mode, where you enter the boot command and the name of the system image to use.Refer the following URL for more information

http://cisco.com/en/US/products/hw/switches/ps718/products_quick_start_chapter09186a00800f029d.html#wp1017074

111
Views
0
Helpful
1
Replies
CreatePlease login to create content