Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Compatible WIC1 DSU T1 with 2651XM?

I am trying to add a WIC1 DSU T1 which uses an RJ connector to this router.

The card does not "power up" when the router is booted and is not seen by the IOS.

I removed a WIC1 DSU 56k, and two WIC T1's from this router before attempting go install the T1 WIC.

I have two cards to test with and neither seems to "light up" when the router is powered, and consequently not seen by the IOS.

Help? I need a compatibility matrix and also a command line configuration steps doc for the install.

This is sho ver:

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-IS-M), Version 12.2(24), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Wed 28-Apr-04 15:30 by kellmill

Image text-base: 0x8000808C, data-base: 0x8111AE9C

ROM: System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1)

usca-sjc-403 uptime is 0 minutes

System returned to ROM by power-on

System image file is "flash:c2600-is-mz.122-24.bin"

cisco 2651XM (MPC860P) processor (revision 0x100) with 125952K/5120K bytes of me

mory.

Processor board ID JAD0626C7S5 (1809622083)

M860 processor: part number 5, mask 2

Bridging software.

X.25 software, Version 3.0.0.

2 FastEthernet/IEEE 802.3 interface(s)

32K bytes of non-volatile configuration memory.

49152K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Compatible WIC1 DSU T1 with 2651XM?

on the 2600XM the min version of IOS which supports this card is 12.2(8)T1 and above you have 12.2 Mainline, move to a later T train or 12.3 Mainline.

3 REPLIES
Hall of Fame Super Bronze

Re: Compatible WIC1 DSU T1 with 2651XM?

Compiled Wed 28-Apr-04 - you have a code that is almost 4 years old. Give it an upgrade and the module will work.

HTH,

__

Edison.

New Member

Re: Compatible WIC1 DSU T1 with 2651XM?

on the 2600XM the min version of IOS which supports this card is 12.2(8)T1 and above you have 12.2 Mainline, move to a later T train or 12.3 Mainline.

New Member

Re: Compatible WIC1 DSU T1 with 2651XM?

Thank you,

I have upgraded to 12-2.8.T5 and it is working.

Thank you very much.

Paul

156
Views
0
Helpful
3
Replies