Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

compression

I'm running into a problem here I'm trying to take off compression on a serial interface. I do the "no" form of the command on the remote router but then when I do the same on the local router I can no longer log back into the remoter router. I've done 2 other routers successfully just this one is giving me problems. Any advice would be greatfully appreciated...Here is the config on the remote end:

interface Serial0/0

ip address 172.19.98.198 255.255.255.252

ip accounting output-packets

ip nat inside

encapsulation frame-relay

no ip route-cache

ip ospf network point-to-point

no ip mroute-cache

fair-queue 64 256 0

service-module t1 timeslots 1-8

frame-relay map ip 172.19.98.197 16 broadcast IETF payload-compression FRF9 stac software

frame-relay lmi-type cisco

Thank you in advance

1 REPLY

Re: compression

What exact command are you negating..

You only need to remove the compression but you would still require the MAP statement

Narayan

96
Views
0
Helpful
1
Replies
CreatePlease to create content