Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Conditional NAT

 

Hi,

We need to implememt conditional nat in a test setup.

Please refer attched ppt for the diagram.

Kindly let us kow how this can be configured cause we tried using route-map with deny statement but its not working.

 

Please help

 

Thanks And Regards

 

Pushpak

3 REPLIES

HelloWhat is it you want to

Hello

What is it you want to NAT? 

 

Res

Paul

Please don't forget to rate any posts that have been helpful. Thanks.
New Member

 Hi,From R5 i will try

 

Hi,

From R5 i will try toaccess 10.9.22.1 with source 10.1.1.1 in this 10.9.22.1 should get translated to 10.8.55.1. ( For 10.9.22.1  10.8.55.1 should reply )

From R5 i will try to access 10.9.22.1 with source 10.1.1.2 in this should  10.9.22.1 should go untranslated . ( 10.9.22.1 will reply ).

 

Thanks And Regards

Pushpak

 

Hello10.8.55.1 is located on

Hello

10.8.55.1 is located on r1 so why do you wish to NAT sourced from an ip on r5 using r1 IP address when communicating to an IP address on R2?

 

res

Paul

Please don't forget to rate any posts that have been helpful. Thanks.
46
Views
0
Helpful
3
Replies