Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Config AIM-ATM-4E1 plus NM-1A-E3 on Cisco 3845 router

Hi Sir,

I am config a Cisco 3845 router ios version 12.3(11r)T2. This router current have a AIM-ATM-4E1 connect to WAN. When I plug in the card NM-1A-E3 into the router. The E1 connection will lose (ATM0/IMA0 will up and line protocol will up but the pvc cannot active) even the E3 card still not be config anthing. How can I make this two card work properly in to the router? This is the current config in the E1 card in router.

controller E1 0/0/0

mode atm aim 0

!

controller E1 0/0/1

mode atm aim 0

!

controller E1 0/1/0

mode atm aim 0

!

controller E1 0/1/1

!

interface ATM0/IMA0

bandwidth 6144

no ip address

no ip redirects

no ip unreachables

no ip proxy-arp

ip route-cache flow

load-interval 30

ntp disable

atm vc-per-vp 1024

no atm auto-configuration

no atm ilmi-keepalive

no atm address-registration

no atm ilmi-enable

!

interface ATM0/IMA0.222 point-to-point

bandwidth 3000

ip address 1.1.12.1 255.255.255.252

ip access-group 135 in

ip access-group 135 out

pvc att-per 1/222

vbr-nrt 5760 5760

oam-pvc manage 0

encapsulation aal5snap

max-reserved-bandwidth 100

!

!

interface ATM0/0/0

bandwidth 2048

no ip address

scrambling-payload

ima-group 0

no atm auto-configuration

no atm ilmi-keepalive

no atm address-registration

no atm ilmi-enable

!

interface ATM0/0/1

bandwidth 2048

no ip address

scrambling-payload

ima-group 0

no atm auto-configuration

no atm ilmi-keepalive

no atm address-registration

no atm ilmi-enable

!

interface ATM0/1/0

bandwidth 2048

no ip address

scrambling-payload

ima-group 0

no atm auto-configuration

no atm ilmi-keepalive

no atm address-registration

no atm ilmi-enable

!

Thank you

1 REPLY
Bronze

Re: Config AIM-ATM-4E1 plus NM-1A-E3 on Cisco 3845 router

Hi ,

Try to put the new card in some other slot .

I faced a similar problem with Cisco 7200 , But I don't know what's going exactly with your config . It's saying that there is 2 Bus Left side Bus1 (Slots 1, 3, 5 ) and right side Bus 2 ( (slots 2, 4, and 6) and cisco is recommending to distribute port adaptor evenly a across left and right slots (buses )

http://www.cisco.com/en/US/docs/routers/7200/configuration/7200_port_adapter_config_guidelines/3875In.html#wp1061412

Regards

?Haris

339
Views
0
Helpful
1
Replies