Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Config Dual T1 DSU card- 2800 series

Hello,

After inserting the card in the Router slot, I don't see the additional controller T1 available, show version tells additional 2 channelized T1's.

How can I configure serial interfaces now ? pelase help.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Config Dual T1 DSU card- 2800 series

Configure "card type t1 " first.

Controllers will appear, for a full T1 configure "channel-group 0 timeslots 1-24".

Serial interface will appear, configure it as usual.

Hope this helps, please rate post if it does!

5 REPLIES
Hall of Fame Super Gold

Re: Config Dual T1 DSU card- 2800 series

Which card exactly ? Do show diag to know.

New Member

Re: Config Dual T1 DSU card- 2800 series

Its VWIC2-2MFT1-T1/E1 2 ports

Thanks

Hall of Fame Super Gold

Re: Config Dual T1 DSU card- 2800 series

Configure "card type t1 " first.

Controllers will appear, for a full T1 configure "channel-group 0 timeslots 1-24".

Serial interface will appear, configure it as usual.

Hope this helps, please rate post if it does!

New Member

Re: Config Dual T1 DSU card- 2800 series

Thanks much.

Hall of Fame Super Gold

Re: Config Dual T1 DSU card- 2800 series

No worries, it happens a lot with the vwic2.

Thanks for the nice rating and good luck!

163
Views
0
Helpful
5
Replies
CreatePlease to create content