The following were added to a Cisco router to enable secure remote access, however the Telnet password is not recognized, thus can not log in to the router. The following is the config. Any suggestions would be appreciated.
I entered a user name and password. Puttying in to the remote router asks for a password. The above password associated with the username did not work. After using Putty to access the router, the username was not asked. Any suggestion would be appreciated.
Create the username with the secret keyword rather than password which will encrypt the password using MD5
username privelege secret
IF your IOS does not support the secret option, you can use service password-encryption in the global config which will also encrypt the password. This encryption though is very weak and can be cracked using any available password cracking tools
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.