Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

config int. to use ISP DHCP

I have a 2600 router and want to connect it to my ISP, how do I config.. the interface to use the ISP DHCP?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: config int. to use ISP DHCP

If all you need is an IP address from your ISP on your router then yes.

Mark

3 REPLIES

Re: config int. to use ISP DHCP

Shane,

You should configure the port connected to your ISP with the following interface command (ip address dhcp".

HTH,

Mark

New Member

Re: config int. to use ISP DHCP

and that is the only command I should put on the interface?

Re: config int. to use ISP DHCP

If all you need is an IP address from your ISP on your router then yes.

Mark

97
Views
0
Helpful
3
Replies
CreatePlease to create content