08-14-2013 07:34 AM - edited 03-04-2019 08:45 PM
Help!
When trying to input commands into the switch I get this error when I enter into the conf t.
_____________________________________________________________________________
Jacobson-2F-4510R#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Jacobson-2F-4510R(config)#int gi3/18
Config mode locked out until standby initializes
configuration mode locked.'Please try later.'
______________________________________________________________________________
It does it when I input any command once I've gone in to configure the terminal. Any suggestions on how I can solve this?
Other information that may be helpful:
Jacobson-2F-4510R#sh redundancy states
my state = 13 -ACTIVE
peer state = 1 -DISABLED
Mode = Duplex
Unit = Primary
Unit ID = 6
Redundancy Mode (Operational) = Stateful Switchover
Redundancy Mode (Configured) = Stateful Switchover
Redundancy State = Stateful Switchover
Manual Swact = disabled (the peer unit is still initializing)
Communications = Up
client count = 63
client_notification_TMR = 240000 milliseconds
keep_alive TMR = 9000 milliseconds
keep_alive count = 0
keep_alive threshold = 18
RF debug mask = 0
________________________________________
Mod Redundancy role Operating mode Redundancy status
----+-------------------+-------------------+----------------------------------
5 Standby Supervisor SSO Disabled
6 Active Supervisor SSO Active
08-14-2013 11:16 PM
Joshua,
In reviewing this, I see that your standby sup in slot 5 is not completely up. It shows as disabled in the redundancy state
Please make a console connection to the standby sup in mod 1 and observe what the current state of this mod is. Please make sure and log all console output. Then you will need to reseat this card. When you have done this please attach the output to the SR as well as a current 'sh tech'.
If possible reseat the module and check the status. It may be that thi sup might be faulty or not able to intereact between the swtich backplane due to some issue which we are nt sure as of now as we dont have complete logs.
HTH
Regards
Inayath
*Plz rate if this info is helpfull.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide