Config Mode Locked. 'Please try later.'

[adamsj]

Help!

When trying to input commands into the switch I get this error when I enter into the conf t.

_____________________________________________________________________________

Jacobson-2F-4510R#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

Jacobson-2F-4510R(config)#int gi3/18

Config mode locked out until standby initializes

configuration mode locked.'Please try later.'

______________________________________________________________________________

It does it when I input any command once I've gone in to configure the terminal. Any suggestions on how I can solve this?

Other information that may be helpful:

Jacobson-2F-4510R#sh redundancy states

         my state = 13 -ACTIVE

       peer state =  1 -DISABLED

             Mode = Duplex

             Unit = Primary

          Unit ID = 6

  Redundancy Mode (Operational) = Stateful Switchover

   Redundancy Mode (Configured) = Stateful Switchover

               Redundancy State = Stateful Switchover

                      Manual Swact = disabled (the peer unit is still initializing)

   Communications = Up

     client count = 63

   client_notification_TMR = 240000 milliseconds

            keep_alive TMR = 9000 milliseconds

          keep_alive count = 0

      keep_alive threshold = 18

             RF debug mask = 0

________________________________________

Mod  Redundancy role     Operating mode      Redundancy status

----+-------------------+-------------------+----------------------------------

5   Standby Supervisor  SSO                 Disabled

6   Active Supervisor   SSO                 Active

[InayathUlla Sharieff]

Joshua,

In reviewing this, I see that your standby sup in slot 5 is not
completely up.  It shows as disabled in the redundancy state

Please make a console connection to the standby sup in mod 1 and observe
what the current state of this mod is.  Please make sure and log all
console output.  Then you will need to reseat this card.  When you have
done this please attach the output to the SR as well as a current 'sh
tech'.

If possible reseat the module and check the status. It may be that thi sup might be faulty or not able to intereact between the swtich backplane due to some issue which we are nt sure as of now as we dont have complete logs.

HTH

Regards

Inayath

*Plz rate if this info is helpfull.