I have a client that currently is running a 1700 series router. In turn this router seems to be having problems so the client decided to purchase a new router (1841).
After getting the config from the older router I have placed this into the new router and now it seems as if the router refuses to talk to the outside world.
I can ping the gateway from clients internally as well as the IP address of the router itself but can not ping past that. From the router I can ping te gateway, it's own IP address but can not ping outside.
Please look below and see if anything sticks out that might be getting in the way.
The ISP is Cinci Bell and I have also chatted with them as well but unfortunately they have nothing to add other than "return the new router"?
Here is the config and I will be happy to add additional comments if needed. Thanks a Bunch....
From Old Router...
Current configuration : 1757 bytes
service timestamps debug uptime
service timestamps log uptime
no logging buffered
no logging console
no logging monitor
no logging on
enable secret xxxx
ip telnet hidden addresses
description --- Ditman Adams LAN ---
ip address 10.1.1.1 255.255.255.0
ip nat inside
description --- Dittman Adams to Fuse ---
ip address 66.161.x.x.x.255.252
ip nat outside
ip nat pool natpool 216.x.x.129 220.127.116.11 netmask 255.255.255.224
ip nat inside source list 100 pool natpool overload
Perhaps I am a bit confused. In the original post you state that the 1700 had some problems but did not specify what the problems were. You state that the new router is not able to get connectivity to outside. You post the config of the old router but not the config of the new router. Which router do you want us to make suggestions about? If it is the new router (as I assume it is) then please post the config from the new router.
It would also be helpful if you would post the output of show ip interface brief.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...