Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Config serial int as well as serial controller?

I'm getting ready to start configuring on a new 3845 ISR with a NM-1T3/E3. After reviewing lots of documents as well as forum searches, I'm not sure if I have to configure the routers serial interface in addition to setting the NM-1T3/E3 card type, controller slot, framing…

Thanks

1 REPLY
Hall of Fame Super Gold

Re: Config serial int as well as serial controller?

You configure:

card-type (mandatory)

controller (optional, in most cases no changes to default)

interface (of course, mandatory)

105
Views
5
Helpful
1
Replies