I have a client that was using thier Merlin Magix PBX to handle the inbound T1. The CSU\DSU failed and they were unable to obtain a new card that could support it. I am installing a 2600 router with a 1MFT-T1 card and the original wic 1T serial card that connected to the PBX. I have the data connected and running fine on channels 1 -12 from the T1 on the controller card, but I am not sure how to configure the phone channels on 13-23 to use the wic 1T serial card to connect and talk to the PBX??
Re: config to split a T1 for data and voice to a PBX
So I can't use the serial card. I need either a dual port card can I use 2 1MFT cards? If I have the 2 ports I am guessing I setup each port for thier respective channels and one port will accept the incoming T1 and the other will go into the CSU/DSU port on the Phone switch? What do I need in the config so that it understands to send channels 13-23 from the T1 into the other MFT port?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.