09-10-2009 07:59 AM - last edited on 03-25-2019 03:26 PM by ciscomoderator
what basic command do i type
1. i want to trak all mac address learnt from port r0/2 on a switch.
2.nms server is 192.168.1.1/24
3.ip add = 2.2.2.2/8
09-11-2009 03:14 AM
Hello Kennie,
you should provide more details:
are you looking for IOS commands or for commands to be given on NMS server to perform an SNMP walk?
in first case
1) sh mac-address-table int typex/y
2) snmp-server community
3) what is the switch management ip address?
Hope to help
Giuseppe
09-11-2009 06:55 AM
i want ios command on the switch to achieve this, the management ip of the switch can be 2.2.2.2/8 ...also.
2. What command will i use to configure a switch so that if password recovery is perform, automatically, the start-up config is delated.
09-12-2009 05:38 PM
interface vlan 1
ip add 2.2.2.2 255.0.0.0
no shut
Password recover of a switch is very simple. Hold down the "mode" button, apply power and, depending on the model, wait for either 10 seconds or port 1 changes color. Go to rommon, enter flash_init, boot_helper and delete "config.text" file. Viola!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: