04-12-2007 11:06 AM - edited 03-03-2019 04:31 PM
Hi there,
I have two Cisco 2851 routers each with a VWIC-2MFT-E1 module. What kind of cable should I use to connect them point-to-point in a close distance and if possible any working configuration.
Thanks,
Klean...
04-12-2007 11:34 PM
Hi
You need to reverse the pin outs on the other end connecting to the router.
Normally the signal comes on 1,2 & 4,5 pairs ,one side you keep this and on the other side you just reverse the same which i feel should work..
http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b6e0f.shtml
regds
04-12-2007 11:37 PM
Yes a back to back T1/E1 cable works
1--4
2--5
HTH, rate if it does
Narayan
04-12-2007 11:46 PM
Hi
You need to use cross cable , with pin detail are below
1--4
2--5
4--1
5--2
if i am recall correctly , 1&2 are RX and 4&5 are TX.
-Minu
please rate this post.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: