Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configuration of VWIC-2MFT-E1 between two routers

Hi there,

I have two Cisco 2851 routers each with a VWIC-2MFT-E1 module. What kind of cable should I use to connect them point-to-point in a close distance and if possible any working configuration.

Thanks,

Klean...

3 REPLIES

Re: Configuration of VWIC-2MFT-E1 between two routers

Hi

You need to reverse the pin outs on the other end connecting to the router.

Normally the signal comes on 1,2 & 4,5 pairs ,one side you keep this and on the other side you just reverse the same which i feel should work..

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b6e0f.shtml

regds

Re: Configuration of VWIC-2MFT-E1 between two routers

Yes a back to back T1/E1 cable works

1--4

2--5

HTH, rate if it does

Narayan

Bronze

Re: Configuration of VWIC-2MFT-E1 between two routers

Hi

You need to use cross cable , with pin detail are below

1--4

2--5

4--1

5--2

if i am recall correctly , 1&2 are RX and 4&5 are TX.

-Minu

please rate this post.

290
Views
0
Helpful
3
Replies
CreatePlease to create content