Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Configuration of VWIC-2MFT-E1 on Cisco 3845 router

Please see attached word document for details.

many thanks

2 REPLIES
Silver

Re: Configuration of VWIC-2MFT-E1 on Cisco 3845 router

Hi,

By default it takes CRC-4 framing, Please try framing no-crc4 command under the Controller (Interface ) and try.

Second, Use Extended Access-group list, mean instead of 1 access-group use 101. and that muct be permitted in access-list.

Third.. check keep alive.

four.. Check correct switch type that is provided by ISP.

This is only end to end solution for L-2 Down.

Regards,

Dharmesh Purohit

New Member

Re: Configuration of VWIC-2MFT-E1 on Cisco 3845 router

Thanks Dharmesh,

The E1 service uses CRC4 Framing and HDB3 Line Coding. I will check all the others.

Thanks again & kind regards

514
Views
0
Helpful
2
Replies
CreatePlease to create content