Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Configuration steps for IP Multicast.

Hi all,

 

         Iam having a 7606 router and it is directly connected by two swithces and one PC.One of the switch1 is the source of the multicast and destinations are are either in switch2 or PC.

Iam having very limited concept strength in Multicast.(Not much time to read and build the same)

Please lemme know which mode i need to take?(sparse/dense)

Which are the configuration steps to achieve the same?

steps of concepts ?

Any help would be very much appreciable.

Thanks in advance.

Mahesh

1 REPLY

Re: Configuration steps for IP Multicast.

Hi all,

        Iam having a 7606 router and it is directly connected by two swithces and one PC.One of the switch1 is the source of the multicast and destinations are are either in switch2 or PC.

Iam having very limited concept strength in Multicast.(Not much time to read and build the same)

Please lemme know which mode i need to take?(sparse/dense)

Which are the configuration steps to achieve the same?

steps of concepts ?

Any help would be very much appreciable.

Thanks in advance.

Mahesh

Hi Mahesh,

Check out the below links for step by step configuration of IP Multicast configuration

http://www.cisco.com/en/US/tech/tk828/technologies_tech_note09186a0080094821.shtml

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

769
Views
0
Helpful
1
Replies
CreatePlease to create content