Configuration table got erased, now we're in trouble
We have a pair of 3725 routers that had been working fine until a power outage. Now one of the routers lost its configuration data and we are having problems restoring it to its old state.
No matter what we do we always get "line protocol down" on both ends. We matched the MUTs, BW, DLY, etc yet all we RX are CRC errors.
I'm not sure if this is an issue, but on one end we are using an Hssi interface and on the other end we have a serial interface. Does this make sense? Because it makes zero sense to me, but then I'm a total noob.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...