Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Configure an NM-1T3/E3 in a 3945

First time configuring a DS-3. Looking for some configuration help with my DS-3. Looking for a basic configuration to get the line up and working. Any help would be appreciated.

Thanks,

Dan

3 REPLIES
New Member

Configure an NM-1T3/E3 in a 3945

Hi Dan,

You would need to match/get some settings from your provider (dsu mode, scramble, encapsulation, clocking, etc), you would also need to add the card type command in order to set the operation mode, here is a document you can use as reference:

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/cisco_ios_isdn_voice_configuration_guide/isdn03.html#wp1066569

Regards.

New Member

Configure an NM-1T3/E3 in a 3945

Thanks Juan,

I have been working on getting this information for some time. Sometimes I think IPS's don't get it.

Dan

New Member

Configure an NM-1T3/E3 in a 3945

You are welcome Dan!

1220
Views
5
Helpful
3
Replies
CreatePlease to create content