Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configure fractional channelized T1

Hi,


I have a ds3 capable of 28 full channelized T1s.  I need to configure one of them for 768k.  Would I just configure this to say

t1 1 channel-group 1 timeslots 1-12 instead of t1 1 channel-group 1 timeslots 1-24  on the cpe and pe router?  just the pe?

Thank you

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: configure fractional channelized T1

Hello Ikadick,

you need to configure on both ends as both parts need to agree on what DS0 timeslots are usable.

on PE side you need to configure the DS3 and the T1, if the CE has a T1 you will configure only that

Be aware that RED or ADM in the middle may not able to multiplex sub T1 / sub E1 so it may be not possible to use B channels 13-24 for another customer (it depends on RED/ADM capabilities)

see for example:

http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/10000series/10cfgchspa.html#wp1067532

Hope to help

Giuseppe

1 REPLY
Hall of Fame Super Silver

Re: configure fractional channelized T1

Hello Ikadick,

you need to configure on both ends as both parts need to agree on what DS0 timeslots are usable.

on PE side you need to configure the DS3 and the T1, if the CE has a T1 you will configure only that

Be aware that RED or ADM in the middle may not able to multiplex sub T1 / sub E1 so it may be not possible to use B channels 13-24 for another customer (it depends on RED/ADM capabilities)

see for example:

http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/10000series/10cfgchspa.html#wp1067532

Hope to help

Giuseppe

476
Views
0
Helpful
1
Replies