Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Configure MSFC2 to use slot 0: for crashinfo

Hi group

Installing new (24MB) flashcards into slot0 of Supervisor card (SUP-2) which also has a MSFC2 card.

What is the command to use in order to make the MSFC2 card to dump crashinfo files to slot0 (flashcard on SUP2engine card)

Catalyst6500 in hybrid mode

I suppose a rhetrorical question maybe - why would you want to do that if the default bootflash (for crahinfo files) is 32MB ?

Don't care - just want to know if can make flashcard the dump device for crashinfo files

Thanks

Jim

269
Views
0
Helpful
0
Replies
CreatePlease to create content