Configure SIP for 7600

[Arjun Dabol]

Hello Experts,

If I have SIP-200 and I need to configure a feature , for eg - PPP on SIP-200 , is it something possible ? If Yes how I can do that in IOS ?

Thanks

[nkarpysh · Accepted solution]

Hello,

SIP-200 itself does support PPP:

http://www.cisco.com/en/US/prod/collateral/routers/ps368/product_data_sheet0900aecd8027c9df.html

However based on the line (cable) you have  you will further need to select SPA. E.G. there are T1/E1 SPAs available where you can directly connect serial line and the configure that for PPP.

E.G.

http://www.cisco.com/en/US/products/hw/routers/ps368/module_installation_and_configuration_guides_chapter09186a008043ff58.html

In case of optics you can install optical SPA and split SONEt into differnt tugs which can be later used as Serial lines over and optical channel.

E.G.

http://www.cisco.com/en/US/partner/docs/interfaces_modules/shared_port_adapters/configuration/7600series/76cfstm1.html

Hope this helps.

Nik