Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure SM-X.1T3/E3 Enhanced Service Module on 3925 Router with T3 Line

I already configured the following: Card Type and Controller for T3 Interface
                                                             - card type t3 1

                                                             - controller t3 1/0

                                                             - framing c-bit

                                                             - cablelegnth 300

                                                             - clock source line

                                                       DSU Mode and Bandwidth
                                                             - dsu mode 1

                                                             - dsu bandwidth 44210

                                                       Primary IP Addess
 

show controller t3 1/0 is down..
 

How to set loopbacks to verify T3 configuration on 3925 router.

Interface SM1/1: do I have to assign an IP Address or use the default  192.168.2.1 255.25.255.240 in this inferface.

1 REPLY
New Member

How did you resolve?

How did you resolve?

233
Views
0
Helpful
1
Replies
CreatePlease login to create content