cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
286
Views
0
Helpful
3
Replies

Configure switch from firewall.

cting1974
Level 1
Level 1

We have a Cisco 2950 managable switch. It's sitting between our ISP router and our own firewall. It's configured with its own private IP network. We want to be able to manage it from behind our firewall. Is this possible? Please show me the directions to it. Thanks

3 Replies 3

rais
Level 7
Level 7

All you need to do is to add routes on your internal network for that switch Telnet address and add internal host IP to the switch.

Allow telnet out to that IP, if not already permitted.

Thanks.

I configured the switch's default gateway using my FW's IP, I also added a static route to the switch in the firewall. But it's still not working yet. I cannot ping the switch from internal network. The switch I have is a Ciso Catalyst 2950 layer 2 switch. I heard I would need a layer 3 switch to do what I ask for? Please confirm.

open a policy in FW

internal ip>>>>switch ip allow telnet permit and no NAT

switch ip >>>>>>internal network allow and telent permitted

HTH if than rate

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: