configureing PPPOE on cisco 1841 router

[zeuscyril]

hi friends,

i am having broadband connection from my ISP .. it is RJ45 connection i need to configure this connection in 1841 router..

but the ISP given me username and password to get internet by dailing..

how i will configure using ethernt interface in cisco 1841 router.

[Giuseppe Larosa]

Hello Cyril,

see this example

https://www.cisco.com/en/US/products/hw/routers/ps380/products_configuration_example09186a0080094475.shtml

you don't need the vpdn part if your IOS is recent.

username and password has to be added to dialer interface configuration with commands like

int dialer 1

ppp authentication chap pap

you can configure username and password using

username xxx password yyy

in global config mode

Hope to help

Giuseppe

[zeuscyril]

hi

i am using 1841 router and my interface cable is RJ45 cable not ADSL cable RJ11.

so i need to connect any one of the fast ethernet port in 1841 then how i can use dialer interface..

it is possible

[Giuseppe Larosa]

Hello Cyril,

it is possible sorry for my misunderstanding

interface FastEthernet0/0

no ip address

speed auto

full-duplex

pppoe enable

pppoe-client dial-pool-number 1

this links to dialer interface

interface Dialer0

ip address negotiated

ip access-group 105 in

ip mtu 1454

ip nat outside

encapsulation ppp

ip tcp adjust-mss 1414

no ip mroute-cache

dialer pool 1

dialer idle-timeout 0

dialer-group 1

ppp authentication pap callin

ppp chap hostname johnroche

ppp chap password pppoeisgreat

ppp chap refuse

!

ip route 0.0.0.0 0.0.0.0 Dialer0

on internal interface

int f0/1

ip address 192.168.11.250 255.255.255.0

ip nat inside

speed 100

full-duplex

!

ip nat inside source list 101 interface Dialer0 overload

access-list 101 permit ip 192.168.11.0 0.0.0.255 any

Hope to help

Giuseppe

[abymltm]

if i have a vlan  in that wan connection how can configure pppoe 

can you give guideline for me

[harry]

Hi,

It's not a case since this is router's port not a switch port.

Regards,