Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

configuring ACE for Probes

I have a question concerning setting up of Probes...I'm looking through the Load Balancing config guide and it refers to Probes being setup and the fact that by default, the probe uses the IP address of the server OR server farm that is configured.

Does this mean, for example, if I have 4 servers in my server farm, it will execute the Probe against all 4 of the servers listed as part of the server farm?

thanks

Bruce

1 ACCEPTED SOLUTION

Accepted Solutions

Re: configuring ACE for Probes

Nope, just set it for the farm.

4 REPLIES

Re: configuring ACE for Probes

Yes it will, it will verify that each server is up and can be a member of the farm. If anyone server fails it's probes, it can automatically be removed from the farm until the probes are successful.

Hope that helps.

New Member

Re: configuring ACE for Probes

thanks for the info...

so, if you configure the probe for the Farm, is it necessary to set a probe (same probe) for each individual server? I would think no...

bruce

Re: configuring ACE for Probes

Nope, just set it for the farm.

New Member

Re: configuring ACE for Probes

thanks...

308
Views
0
Helpful
4
Replies