Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
264
Views
0
Helpful
1
Replies

configuring cable modem to work with 1841

thomas.desillier
Level 1
Level 1

‎10-26-2006 07:30 PM - edited ‎03-03-2019 02:29 PM

I currently have a frame relay wan kicking. and are trying to hook up a cablemodem to the ethernet port. here is the configuration: wan (frame relay) on s/o . ethernet 0 has local lan, and I want to connect the private cable network to the other ethernet,I have to provide the ip address. how would this configuration look like? also I have 19 locations to connect.

Labels:
0 Helpful
1 Reply 1

vivejain
Level 1
Level 1

‎10-26-2006 09:22 PM

Hi Thomas,

The cable modem(CM) should obtain the IP address from the CMTS. CM will receive an Private IP address from CMTS for WAN link and PCs connected will receive Public IPs. This is all done via DHCP and no configuration is required.

Let me know if this helps.

Cheers

Vivek

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card