I am migrating a group of modems from old Cisco routers to a 3845 Router with HWIC-16A card. In the old routers it was all serial interfaces & encapsulation was either PPP or not mentioned. In the new router the interfaces are coming up as
interface Async 0/0/0 etc.
Do I need to just give the IP address below this or anything more? On checking documents under IOS Dial Configuration Guide, there are async mode dedicated/interactive etc.Do I need to use these commands? Also, there are lines coming up as line 0/0/0 0/0/15 beneath line aux. Do I need to configure anything here. Again, I am using a HD-CAB-KIT cable for this connection, when I connected to the ethernet port of a modem, the physical and line protocol was showing down and down. Do I need to make some changes in the modem for correcting this?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...