Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configuring interface IMA

Hi,

I would configure an interface IMA on C3660 . Now, I have an interface atm active (link 2) and another in shut but linked (link 3).

the final scenario is that these interface belong to an IMA group and one link is active.

I have configured the ima-group and I have created the new interface ima using the following command:

ma clock-mode common

ima differential-delay-maximum 75

ima active-links-minimum 1

ima test link 3

ima test link 2

Now, I have a doubt about the ip address to configure. Does this address must be the same at the ip address now configured on active interface ATM?

Do I have to cancel the actual address on active interface?

Thank you.

Regrads, paolo

1 REPLY
Silver

Re: configuring interface IMA

IMA allows you to aggregate multiple low-speed links into one larger virtual trunk or IMA group. An inverse multiplexer appears to your ATM switch router as one logical pipe. This IMA group provides modular bandwidth for user access to ATM networks for connections between ATM network elements at rates between the traditional order multiplex levels, such as between T1 or E1 and T3 or E3. For more information follow the url ,

http://www.cisco.com/en/US/products/hw/switches/ps718/products_configuration_guide_chapter09186a00800f01b8.html

102
Views
0
Helpful
1
Replies