Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

Configuring IP SLA for 5 locations in continuous intervals

Hi,

I have a 2811 (located in a central location) with NM HDV card and 5 Cisco AS5400 boxes in various locations. My aim is to monitor the VOIP call statistics of this 5 locations from the central location. I can configure IP SLA based RTP VOIP Operation to do this. But at a time i can only monitor the statistics to one location. But i would like to monitor the 5 locations in continuous intervals. How do we achieve this with the help of "ip sla schedule" configuration... Is it possible...

For eg...

for first 30 seconds monitor location 1

next 30 seconds monitor location 2

and so on...

after location 5 again i have to monitor location 1...

is it possible to do this kind..

thanks in advance

regards,

arun kumar

1 REPLY
New Member

Re: Configuring IP SLA for 5 locations in continuous intervals

Hello Arun,

There are two ways to do this.

1. start-time

what first option will do is that it will poll that destination once a day for particular time. Configure all the 5 destinations to start at different time of the day.

2. ip sla

icmp-echo source-interface

frequency

use these options to start all the polling at different time of the day after the same frequency interval. For example start pinging 2.2.2.2 at 14:00 hours with an interval of 120 seconds. start pinging 2.2.2.3 at 14:02 with an interval of 120 seconds and so on. Just do your maths before you try that.

Hope this works.

Rgds.

OJ

Vote this thread if it works.

121
Views
0
Helpful
1
Replies
CreatePlease to create content