Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

configuring pppoe in cisco CLI (VPDN or bba-group)???

Hi All,

My scenario is like below:

Cisco 1841 or 2811 router -- DSL modem --- Aggregation router.

Cisco 1841 or 2811 should initiate a PPPOE to the Aggregation router.

When I started configuring PPPoE, i am not able to find the "protocol pppoe" option under vpdn group. (though on Cisco's FN pppoe-client support is listed on the IOS)

LAB-CE2-1841(config)#vpdn-group 1

LAB-CE2-1841(config-vpdn)#pro

LAB-CE2-1841(config-vpdn)#pro?

% Unrecognized command

LAB-CE2-1841(config-vpdn)#reque

LAB-CE2-1841(config-vpdn)#request-diali

LAB-CE2-1841(config-vpdn)#request-dialin

LAB-CE2-1841(config-vpdn-req-in)#pro

LAB-CE2-1841(config-vpdn-req-in)#protocol ?

l2f Use L2F

l2tp Use L2TP

LAB-CE2-1841(config-vpdn-req-in)#protocol

This above router should initiate a PPPoE to the Aggregation router.

Just came across about the "bba-group pppoe" config CLI. Would like to know currently PPPoE under VPDN is replaced with bba-group CLI.

Or bba-group CLI should only be used on the aggregator side.

Any help is much appreciated.

thanks

Arun Kumar

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: configuring pppoe in cisco CLI (VPDN or bba-group)???

Hello Arun,

there was a change and newer IOS versions simply don't need to configure VPDN to support PPPoE client

you need just to configure under fe port

int fe0/0

pppoe-client dial-pool-number 1

+

int dialer

interface Dialer1

ip address negotiated

ip mtu 1492

bba-group is needed if you want to use more then one PPPoE session

Hope to help

Giuseppe

3 REPLIES
Hall of Fame Super Silver

Re: configuring pppoe in cisco CLI (VPDN or bba-group)???

Hello Arun,

there was a change and newer IOS versions simply don't need to configure VPDN to support PPPoE client

you need just to configure under fe port

int fe0/0

pppoe-client dial-pool-number 1

+

int dialer

interface Dialer1

ip address negotiated

ip mtu 1492

bba-group is needed if you want to use more then one PPPoE session

Hope to help

Giuseppe

Bronze

Re: configuring pppoe in cisco CLI (VPDN or bba-group)???

Hi Giuseppe,

Thanks for your valuable help. It is working.

thanks

Arun Kumar

New Member

Do you need to use  pppoe

Do you need to use 

 

pppoe enable group global

 

?

2617
Views
5
Helpful
3
Replies
CreatePlease to create content