Does you policy use absolute bandwidth values? Does the policy's total bandwidth exceed the interface's bandwidth? If so, I've seen IOS quietly drop the policy at the command line. (Belive it syslogs it, though.)
If your are using absolute bandwidth values in your policy, trying using percentage based bandwidth values.
Shapers throttle traffic; setting a maximum bandwidth allowance. The bandwidth statement sets a minimum allowance, except for LLQ where it also is a rate limiter. If this is what you intend, shouldn't be an issue.
Normally, you allow classes to use excess bandwidth.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.