One 1ENET and a DB60 serial interface to two different service providers with two different Ip addresses. I also have a single fa0 interface which connects to the LAN. I need this LAN to NAT and connect to the internet via one of the interfaces and in the event of a failure of one of the interfaces it should fall on the other service provider link. How best do I achieve this to ensure connectivity at all times. I also do not need load balancing so I guess I can use floating static routes as I have only static routes in operation.
Re: CONFIGURING REDUNDANCY WITH TWO SERVICE PROVIDERS
You can use floating static routes to do Active/Standby routes.I would concern about Nat for this.You should use route-map commands to tell the router what's the right interface that we want to do Nat functions. Because of the nat operations will do what we defined.The router doesn't care about what is the active interface at that time.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...