We have 16 port switching module on 3800 ISR with the following configuration.
Fa0/1 - 10.1.1.1 / 24 ( LAN ).
Fa 0/0 - WAN - ISP connectivity.
Subnet for LAN is 10.1.1.0 /24. How do we configure this switch module to support this LAN subnet, all hosts has default gateway of 10.1.1.1. That is how do we logically connect switch module to fa 0/0 port of router.
Is it so that, switch module logically act as another L3 interface. With L2 switch connected to it. So that VLAN ip address of that module will be default gateway of all hosts conncted to that switch.
Please share the experience.
Any link on configuring switch module on cisco.com is appreciable.
Thanks for your update. That means Vlan1 is in itself another L3 interface. Which can take part in routing. If we move all configuaration of Fa0/1 to Vlan1 it will take part in routing plus Fa0/1 interface will be free for another use.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...