10-14-2005 05:16 AM - edited 03-03-2019 10:43 AM
I have looked through the cisco documentation and could not find what the FE Management Port on the 7304 NSE-100 processor is used for or how it can be used and configured.
10-14-2005 05:53 AM
Hi
See the link below for the config guide
http://www.aarnet.edu.au/engineering/site/install/cisco-7304-installation.pdf
Hope its of some use.
10-14-2005 06:14 AM
Thanks but this document does not explain how the FE management port can be used. I would like to use it as a standard FastEthernet interface if possible.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide