02-05-2010 12:13 PM - edited 03-04-2019 07:25 AM
Hello,
I have a question regarding configuring WCCP for WAAS. If I have a subinterface does the "ip wccp 62 redirect in" command need to be placed on the physical interface only, on the subinterface, or on both interfaces? Thanks.
02-12-2010 03:03 PM
Hi,
WCCP redirection needs to be configured on the Layer 3 interface (or subinterface) where the ip traffic that needs to be redirected is arriving. Hence, if your main interface does not have an IP address and/or is not receiving ip traffic that needs to be redirected only the subinterface requires this configuration.
Regards,
Rick.
11-04-2010 09:29 AM
Can the WCCP be added to a VLAN (SVI) interface on a 3560 switch? Or do each of the interfaces need to be L3. Current internet connection is on a flat vlan, PIX and DMZ router are connected to L2 interfaces on the switch, but their addresses are in the same subnet. Do I need to change the DMZ router and PIX interfaces to point-to-point L3 ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: