Can anyone please help me out!!! i have got the 2 MB LL which is normally congested i wana see what sort of the traffic is making my link congested.
I donot have the access to other router and i want to keep a check on unwanted traffic on my serial interface ,i had tried the
Sh ip cache flow and
Sh ip accounting
to check the source port , ip address and size of traffic i am getting .But i am not satisfied with the output since it does not reflect the clear picture .....
Is it possible to do a port mirrioring on the router and that too on serial interface or any such way is available which could give me sniffed data hitting the serial, which will help me to implemnet QoS , ACl and route maps .
Thanks a lot for that much quick responce .I had added the deny entries in ACL as per the output of the command the traffic is now something near to 70 percent of the link .But once the link had became congested and that too at peak hours hence i think i should implement good class map on the interface to give the proper BW to the each application. but without sniffed data of Wan interface it is difficult to make decision on changing DSCP value as per the source ip add. so is it possible to have the monitor session or any thing like that on router .....
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.