Connecting 2 routers back to back via Console and AUX ports
I have (2) 3925 routers next to eachother
Router 1 is my Primary and I have a modem connected to it via the AUX port
Router 2 is standby and I do not have any connections to it at all. This router was configured the same as the primary initially but changes have been made to primary that were not applied to secondary router.
My question is:
Can i use the CONSOLE port on the Router 1 Primary router to connect to the AUX port on the Router 2 secondary router to gain access to secondary router and then apply latest config.
From what I have read it looks as though the Source router, Router 1, has to use the AUX port to connect to destination router, Router 2, CONSOLE port
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...