Connecting E1 G.703/G.704 120-OHM to Black Box G.703 to Ethernet Bridge
This problem has been bugging me for the last few days. I cannot seem to get the physical layer up for the connection between the DB-15 presentation on the E1 card on my 7206VXR and my BlackBox G.703 converter on RJ-48C.
I have tried various pinouts and am now losing my rag with it. I can get my line working on an 8-port port adapter card but not this card.
The following is my config on the serial interface:
interface serial 1/0
clock source internal
If anyone could suggest anything I would be eternally grateful.
Re: Connecting E1 G.703/G.704 120-OHM to Black Box G.703 to Ethe
Uh, no unfortunately.
The card has implicit controllers in the serial interfaces so you can only run "show controller serial x/y". I can do a "show controller e1" but will not take any other input and when I commit that command it comes back empty.
Just to confirm, the card in question is a 4-port E1 G.703/G.704 120 OHM
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.