Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connecting IGX to 2610

For training purposes, i am trying to connect the IGX to 2610. IGX has UFM 4C Back card with db-15 interface, 2610 has wic-2t installed on it.

Could anyone help me to connect these two devices back-to-back?

P.S:I have done this task before by putting an E1 Mainstreet between them acting as Telco. But now, i have lost my documentation of thsi method.

3 REPLIES
Purple

Re: Connecting IGX to 2610

Hi,

To connect these two, make a DB15 to RJ45 cable with the following connections:

RJ45 -- DB15

1 -- 3

2 -- 11

3 -- 4

4 -- 1

5 -- 9

6 -- 2

Hope that helps - pls rate the post if it does.

Paresh

New Member

Re: Connecting IGX to 2610

Paresh,

Thank you for your advice but, the type of connector on the 2610 is smart serial not rj-45, how can i connect a smart serial interface to a DB-15 interface with correct signaling?

Purple

Re: Connecting IGX to 2610

Whoops.. my apologies there.. I should have read your post a bit more carefully.

That's an interesting one. You are going between a serial interface and an x21 so a simple cable isn't going to hack it. You are going to need a box with some active circuitry to convert between the two, I guess. I've used an x21 to E1 converter from Nokia (DNT2M-G) for this purpose for some customers. Not sure you really wanted to buy something...

Paresh.

109
Views
3
Helpful
3
Replies
CreatePlease login to create content