You have not given enough information for us to be sure what the issue is. You have given us the config of one router and 1 IP address from the other router. At a minimum we need to know what is the addressing of the LAN on the other router.
As was pointed out in a previous post there does not appear to be any static routes or any dynamic routing protocol in the config that you posted. Without either static routes or dynamic routing protocol the router will have no knowledge of how to reach the LAN of the other router, producing the symptoms that you describe.
At this point I would make a guess that the second router may also be using 192.168.0.0/16 on its LAN. If so this would be a problem. If router 1 believes that 192.168.0.0/16 is local then it will never send any traffic over the serial attempting to reach 192.168.0.0/16 on the other router.
what you can do is, juz configure the 192.168.10.1/24 ip address on fas 0/1 interface on Router A & on Router B fas 0/1 configure the ip address as 192.168.20.1/24, & give the gateway to the PC, your problem will be solved.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...