Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connection 2 Router using VWIC-T1 2MFT card

I have been trying to connect two router together for a lab both has a VWIC-T1 2MFT card i can't get it to work. can someone help?

3 REPLIES

Re: Connection 2 Router using VWIC-T1 2MFT card

Are these back to back routers? What cable/pinout are you trying to use? Do you have configs that you can post.

Please note that you will need a special T-1 crossover cable and a standard patch cable will not work.

http://www.cisco.com/en/US/docs/wireless/cards/t1e1vwic/1941cvwic/c1941wic.html#wp1070542

HTH,

Mark

New Member

Re: Connection 2 Router using VWIC-T1 2MFT card

what do youe mean by back to back? from one router to the other if that yes.

i was using a UTP Xover cable. i don't have any config yet.

Re: Connection 2 Router using VWIC-T1 2MFT card

First I would say that you will need to purchase/make a cable for your lab.

T1 cross-over cable pinout:

* pin 1 to 4

* pin 2 to 5

* pin 4 to 1

* pin 5 to 2

HTH,

Mark

393
Views
0
Helpful
3
Replies