Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connection of Router to another link

I have the conection that is annex here.

The router "C" is connected to router "B" via eigrp.

Router "A" is connected to firewall via rip.

Router "A" is a hub frame relay and connect with all routers via eigrp.

I Need connect Router C with Router A via Eigrp.

Do I can make all configuration and leave the same subnet 1.1.1.1/2 in the interface of the router "A" up and then go where is Router "C and connect the cable v.35 to another service provider?.

Leave the serial interface up, with the same IP 1.1.1.1/2, until it reaches the place where this router C, i can generate any problem of communication?

1 REPLY
Hall of Fame Super Bronze

Re: Connection of Router to another link

Pedro,

The router won't allow you to have the same subnet on multiple interfaces.

HTH,

__

Edison.

104
Views
3
Helpful
1
Replies