Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cons to aux connection

Hi All,

I have a router at a remote site and want to configure a new router remotly. For that i want to connect a roll over cable from old router aux port to new router console port.

How do i access the new router after telneting to the old router. Is the any initial configuration to be done prior to connect to the new rourer.

Appreciate your help.

1 REPLY
Gold

Re: cons to aux connection

On old router

line aux 0

transport input all

exit

and now see the line number of aux port:

show line

it will be number X (1 or 5 or whatever)

then find any live ip (fe. inside IP) address on the router and do reverse telnet like this

telnet 2000+x

if x is 5 then 2000+5=2005

so it's telnet 2005

M.

Hope that helps rate if it does

101
Views
5
Helpful
1
Replies
CreatePlease login to create content